GENERAL SPECIFICATION : | Maximum output power | 500W + 500W (4ohms),
370W + 370W (8ohms/ AC100V model)
350W + 350W (8ohms/ AC120V model)
320W + 320W (8ohms/ AC220-240V model)
@1kHz, THD+N≤0.5% | Total harmonic distortion
(THD+N) @ 20-20kHz | Less than 0.3%, +14dBu output into 600ohms | Frequency response
GAIN=Minimum, PAD=OFF | 0, +0, -3dB, 20Hz-20kHz, 0dB @1kHz | Equivalent input noise
GAIN=Maximum, 20-20kHz | -128dBu | Crosstalk
@ 1kHz | -68dB, adjacent inputs | | -68dB, input to output | | Phantom voltage | +48V on CH1-6,7/8,9/10 | Channel equalizer
+15,-15dB Maximum | HIGH: 10kHz (Shelving) | | MID(MONO): 250Hz-5kHz (Peaking) | | MID(ST) 2.5kHz (Peaking) | | LOW: 100Hz (Shelving) | | Channel peak indicator | LED turns on when post EQ signal reaches -3dB below clipping | | Channel signal indicator | LED turns on when post EQ signal reaches -10dB | | FCL indicator | input level: -75dB | LED Level meter
(ST, PFL/AFL) | 2*12 points LED meter (PEAK,+5,+3,+1,0,-1,-3,-5,-7,-10,-15,-20 dB)
PEAK lights if the signal comes within 3 dB of the clipping level. | Graphic equalizer
(ST OUT) | 9 Band (63,125,250,500,1k,2k,4k,8k,16k Hz), +12/-12 dB Maximum | | Effect | 16 programs, Parameter control
Foot switch(FC5:Option) Digital Effect ON/OFF | | Power amplifier protection | POWER switch on/off mute
DC-fault
Thermal / heatsink temp≥90 & degrees celsius
Vl limiter / RL≤2 ohms
Clip limiter / THD≥1%, Indicator x 2 | | Power supply protection | Thermal / heatsink temp≥100 degrees celsius | | Cooling | Variable-speed fan ( x 2) | | Power consumption | Japan: | AC100V 50/60Hz, 500W | | North America: | AC120V, 60Hz, 500W | | Other Areas: | AC220-240V, 50/60Hz, 500W | Dimensions
(W x H x D) | 444 x 155 x 493 mm | | Weight | 10.5kg | INPUT CHARACTERISTIC | Input terminal | PAD | GAIN | Actual load impedance | For use with nominal | Input level | Connector | | Sensitivity | Nominal | Max. before clip | | CH INPUT A 1-6 | 0dB | -60dB | 3kohms | 50-600 ohm Mics | -80dBu | -60dBu | -40dBu | XLR-3-31 type *3 | | -16dB | -36dBu | -16dBu | +4dBu | | 26dB | -34dB | -54dBu | -34dBu | -14dBu | | +10dB | -10dBu | +10dBu | +30dBu | | CH INPUT B 1-6 | 0dB | -60dB | 10kohms | 600 ohm Lines | -80dBu | -60dBu | -40dBu | TRS phone jack | | -16dB | -36dBu | -16dBu | +4dBu | | 26dB | -34dB | -54dBu | -34dBu | -14dBu | | +10dB | -10dBu | +10dBu | +30dBu | ST CH INPUT
7/8-9/10 | -60dB | 3kohms | 50-600 ohm Mics | -80dBu | -60dBu | -40dBu | XLR-3-31 type | | -16dB | -36dBu | -16dBu | -10dBu | | -34dB | 10kohms | 600ohm Lines | -54dBu | -34dBu | -14dBu | Phone jack | | +10dB | -10dBu | +10dBu | +30dBu | ST CH INPUT
11/12-13/14 | -34dB | 10kohms | 600ohm Lines | -54dBu | -34dBu | -14dBu | Phone jack,
RCA pin jack | | +10dB | -10dBu | +10dBu | +30dBu | | CH INSERT IN (1-6) | - | 10kohms | 600ohm Lines | -20dBu | 0dBu | +20dBu | Phone jack | OUTPUT CHARACTERISTICS | Output terminal | Actual source impedance | For use with nominal | Output level | Connector | | Nominal | Max. before clip | | ST OUT [L,R] | 150ohms | 600ohm Lines | +4dBu | +20dBu | TRS phone jack | | ST SUB OUT [L,R] | 150ohms | 600ohm Lines | +4dBu | +20dBu | TRS phone jack | | AUX SEND 1,2 | 150ohms | 600ohm Lines | +4dBu | +20dBu | TRS phone jack | | EFFECT SEND | 150ohms | 600ohm Lines | +4dBu | +20dBu | TRS phone jack | | CH INSERT OUT 1-6 | 600ohms | 10kohm Lines | 0dBu | +20dBu | TRS phone jack | | REC OUT [L,R] | 600ohms | 10kohm Lines | -10dBV | +10dBV | RCA pin jack | | PHONES [L,R] | 100ohms | 8ohm / 40ohm Lines | 1mW/
3mW | 20mW/
75mW | ST phone jack | | SPEAKER OUT | 0.1ohms | 4ohm Speakers | 125W | 500W | speakON
Phone jack | * 0dBu=0.775Vrms. 0dBV =1.0Vrms
|
